Rolling, pickling and shearing done in Baoji. Gr1–Gr2 for corrosion duty, Gr5/TC4 where strength carries, Gr7 where chlorides get nasty. Thickness 0.4 to 60 mm, width to 2,200 mm, cut-to-length from a single sheet.
Plate over 3 mm and sheet at or under 3 mm are the same product family with different mill tooling — the price gap between them is a rolling-cost artefact, not a quality difference. Where a buyer gets burned is the surface condition: pickled plate for corrosion duty, mill-finish plate for anything going into a machining cell, because the pickle layer interferes with fixture grip and you will face it off anyway.
Every item on this page states the governing specification. If your drawing invokes ASTM B265, buy the B265 line. If it invokes GB/T 3621 only, we can still supply to B265 — but say so on the enquiry, because the tolerance bands and the test set differ.
3–8 mm, because those are the widths the mill runs continuously at Baoji. Below 1 mm you pay for repeated rolling passes; above 25 mm you pay for slab yield. We will show both on the quote so you can decide.
Yes, from one piece, 500 mm minimum length. Adds two days and a per-cut charge stated up front.
Yes — EN 10204 3.1 per heat, available before you order, not only after. Ask for the specific lot number on the enquiry.
We roll to order from 3 t per size. Send thickness, width, length, quantity and destination port.
Ask for a roll Estimate the weight